Part of the data ring
ReadLength
Owens, John Algernon · measured edition

Sword and Pen

11h 08mof reading at 250 wpm

Sword and Pen by Owens, John Algernon runs to 166,906 words — about 11h 08m of reading at an average adult pace of 250 words per minute, or roughly 607 pages at typical paperback density.

Extent 166,906 words · 13,297 distinct forms · 6,004 sentences · F–K grade 13.1

SOURCE·Project Gutenberg full texts·computed from the full text·REVIEWED JUL 2026

Extent — 607 pages against 11h 08m of reading

Above the rule one mark per reading hour at 250 wpmBelow a folio every 50 pages at 275 words to the page

SOURCE·Project Gutenberg full texts·counted from the text, not a publisher's page count·REVIEWED JUL 2026

Words166,906longer than 79% of books here
Reading time11h 08mat 250 wpm
Reading level13.1Flesch–Kincaid grade
Chapters433,882 words each

How this is worked out

  1. The Project Gutenberg plain-text edition is fetched, then Gutenberg's header and licence footer are struck at the *** START *** and *** END *** markers. Nothing is taken from a publisher's listing.
  2. What remains is counted as that edition sets it: 166,906 words, 6,004 sentences, syllables by vowel-group heuristic.
  3. Words are divided by a stated reading rate. This page's headline uses 250 words a minute; a duration printed without its rate cannot be checked, so the rate travels with every figure and the table below runs 150–450 wpm.
  4. Minutes are rounded once, to the nearest minute, and set as h:mm. Nothing on this page is rounded twice.
  5. The page extent is a courtesy conversion at 275 words to the page — a typesetting figure, not a property of the book.
words ÷ rate            = minutes
166,906 ÷ 250 wpm   = 668 min   → 11h 08m
words ÷ density         = extent
166,906 ÷ 275 w/pp  = 607 pages

The method in full, including why your count may differ →

How long it takes to read, by reading speed

Most adults read prose at 200–300 words per minute. Reading speed varies far more between people than most reading-time estimates admit, so here is the whole range.

Reading speedTotal timeAt 30 min/dayAt 1 hour/day
Slow / careful (150 wpm) 18h 33m38 days19 days
Below average (200 wpm) 13h 55m28 days14 days
Average adult (250 wpm) 11h 08m23 days12 days
Fast (300 wpm) 9h 16m19 days10 days
Very fast (450 wpm) 6h 11m13 days7 days

The full measurement

Total words166,906
Unique words13,297
Lexical diversity7.97% unique words as a share of total
Sentences6,004
Average sentence length27.8 words
Average syllables per word1.51
Long words (3+ syllables)12.6%
Chapters detected43 — averaging 3,882 words
Flesch–Kincaid grade13.1
Flesch reading ease51 higher is easier; 60–70 is plain English
Gunning fog index16.2
Coleman–Liau index11

Computed from the Project Gutenberg plain-text edition with the Gutenberg header and licence footer removed. See how and why your count may differ.

SOURCE·Project Gutenberg full texts·ebook no. 28152·REVIEWED JUL 2026

Reading it in evenings

The same 166,906 words, divided by the habit rather than by the hour — and then a rate of your own, if 250 wpm is not yours.

10 min a day 67 days
20 min a day 34 days
30 min a day 23 days
60 min a day 12 days
Worked from the text: 166,906 words ÷ 250 words per minute = 668 minutes of reading, divided by the daily habit and rounded up to whole days.

SOURCE·Project Gutenberg full texts·reading rate stated: 250 wpm·REVIEWED JUL 2026

Average adult prose speed is 200–300 wpm. Not sure? Time yourself on one page.

Is it a hard read?

Four different readability formulas agree it is difficult — college level: Flesch–Kincaid puts it at grade 13.1, Gunning fog at 16.2, Coleman–Liau at 11. The Flesch reading-ease score of 51 is fairly typical of adult fiction.

The mechanics behind that: sentences average 27.8 words (modern prose tends to run 15–20), and 12.6% of words are three syllables or longer. Its vocabulary is moderately varied — 13,297 distinct words, or 7.97% of the total.

A caution about all of this: readability formulas measure sentence and word length, nothing more. They cannot see irony, dialect, allusion or an unreliable narrator. A book can score as "easy" and still be genuinely difficult to follow.

The second question

What people ask once the duration is on the table.

How many words are in Sword and Pen?

166,906 words in the Project Gutenberg edition, made up of 13,297 distinct words across 6,004 sentences. That is longer than 79% of the books measured on this site.

How long does it take to read Sword and Pen?

About 11h 08m at an average adult reading speed of 250 words per minute. A slower reader at 150 wpm would need roughly 18h 33m; a fast reader at 400 wpm about 6h 57m.

What reading level is Sword and Pen?

It scores 13.1 on the Flesch–Kincaid grade scale — difficult — college level. Its Flesch reading-ease score is 51, sentences average 27.8 words, and 12.6% of its words run to three syllables or more.

How many pages is Sword and Pen?

Page counts depend entirely on the edition — font, trim size and margins all change them, which is why this site measures words instead. At a typical trade-paperback density of about 275 words per page, 166,906 words works out to roughly 607 pages.

Colophon

Measured from the Project Gutenberg plain-text edition, ebook no. 28152, with Gutenberg’s header and licence footer struck before counting. 166,906 words, 6,004 sentences, 13,297 distinct forms. No text of the work is set anywhere on this site — only measurements of it.

The extent of 607 pages is a conversion at 275 words to the page, not this edition’s foliation: a page count belongs to a typesetting, never to a book. Reading time assumes 250 words a minute and is stated with its rate everywhere it appears.

SOURCE·Project Gutenberg ebook no. 28152·US public domain·REVIEWED JUL 2026

Word counts and reading levels are computed from a specific public-domain edition and will differ from other editions and from other counting methods — see the method page.

See all 10 sites in this family, with what each one answers

Published by

Amit Sharma

Auckland real-estate agent and marketer. Builds free, sourced data tools.